JETImodel Power Ion 2600 2S1P

  • Modell: JT-22985491
  • 2 stk. på lager
  • Produsent: Jeti

Power-Ion accumulators are battery packs suitable to power the receiv-er and servos in the model.
The main advantages of Power-Ion accumulators include high mechanical resistance due to keeping  in a metal case.
The accumulators are also characterized by a long cycle life.
No balancer is needed for their operation and in case the current is higher than 150A, short circuit protection is activated.
Overcharge protection is activated if the charging voltage is higher than 5V per cell.  
The accumulators are functional even at very low or very high temperatures (-10 - +60°C).

ach pack is provided with one two-wire cable with the JR connector for charging and with one two-wire cable with the MPX connector for connection to the model.
Both cables are of the same length.
The accumulators are supplied in a plastic case and are fastened to it by Velcro. The case itself is screwed to a model using anti-vibration rubber grommets, see the picture below.
Pay attention to correct placing of the brass washer. Its wider part should be in contact with the assembly board to which the battery case is mounted to avoid extruding the material.  

Technical data:
Configuration: 2S
Nominal voltage: 7,2V
End-of-charge voltage: 8,4V
Capacity: 2600mAh
Permanent discharge current: 20A
Max. discharge current: 40A
Max. charge current: 4A (using MPX plug)
Balancer connector: no
Cable length (1x MPX Kabel + 1x JR Kabel): 135mm
Weight: 136g (incl. Holder) / 104g (w/o Holder)
Dimensions: 104x47x32mm (incl. Holder) / 70x39x20mm (w/o Holder)

Batteri og holder

Kunder som har kjøpt dette produktet har også kjøpt:

IP-addressen din er:
Kopirett © 2021 Eureka RC
Drevet av netthandelsløsningen Zen Cart med norsk oversettelse